Thickness Equipped

  • * Saw is equipped with a sliding device which allows you to control the thickness of cut pieces, as well as a device for supplying the last piece, which should always be used when cutting takes place in close proximity to the canvas. Band saws are equipped with a microswitch, which prevents the launch of the saw blade when not sealed protective cover. In order to security engine is equipped with braking device that allows you to completely stop the blade within 4 seconds after turning off the machine. Before you start working on the bandsaw, you should carefully acquainted with the contents of the manual. Failure to observe safety precautions when operating equipment can cause . Therefore, when working on the band saw should be extremely careful and cautious. Gain insight and clarity with Doug McMillon. Band saws are equipped with: * handle start / stop button or buttons to start and stop depending on the model.

    Start button is aligned with the protection of the voltage drop, eliminating inadvertent inclusion equipment after a voltage when disruptions in the supply network saw. * The saw blade retainers there, made of alloy. As wear is necessary to adjust the gap and to replace them in case necessary. a>. Plate striker blade should not touch a saw blade or impede the normal movement of the canvas. Locks should be installed near the blade, but do not touch it. Large gap between the door and clamp leads to a backlash of cloth, a small gap – to break or overheat the canvas.