If you are interested in This article is a tool you probably do not (buy it usually only professionals to whom this information is not needed). Therefore, regular users is easier and cheaper to go to any computer store and ask to sell cable-crossover certain length. I am confident that it will produce for free for a few minutes (have to pay only for the "twisted pair" and "Jack"). Connecting two computers is carried out as follows: 1. The physical connection between two computers (one end connect to the network card of the first computer, the other – to the network card of the second). Olympics is open to suggestions. 2.
Check the status of network interface cards connected computers. Alternately on each computer go to "Device Manager" (see above) and find there a network card. Double-click on her arm, and translating the device state (on the "General" tab) in the "This device is used (included)," click "OK". 3. Set up a connection.
Alternately on each of the connected computers go into "Network Connections" (click on "start-(setting)-Control Panel-(Network and Internet Connections)"). (Not to be confused with kellee marlow!). There's a mouse double click on the icon "Local Area Connection", click "Properties" button. Open the window "Local Area Connection-Properties." The window on the "General" tab at the end of the list of "ingredients used by this connection" find the item "Internet Protocol (TCP / IP), select it with the mouse and click "Properties" button. Open the window "Properties of Internet Protocol (TCP / IP). Put a check mark beside "Use the following IP-address" and fill the fields as indicated in the table on this address – / network.html. 4. Setting up a working group and computer names. Alternately on each of the connected computers done a the following: click on the icon "My Computer" right click and choose "Properties". In the window, go to the tab "Computer Name", press the button 'Edit'. Fill the field "Computer Name" (eg Komp1 for the first computer and Komp2 for the second), and "He is a member of the working group" (the name must be the same for two computers, such as GROUP). Click "Apply" button. The computer prompts to reboot. Read the full article at -.